Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Networking
»
Networking Basics
You have 10 users plugged into a hub running 10Mbps half-duplex. There is a server connected to the switch running 10Mbps half-duplex as well. How much bandwidth does each host have to the server?
100 kbps
1 Mbps
2 Mbps
10 Mbps
Correct Answer:
10 Mbps
Explanation:
Each device has 10 Mbps to the server.
← Previous Question
Next Question→
More Questions from
Networking Basics
What does a VLAN do?
What protocols are used to configure trunking on a switch? VLAN Trunking Protocol VLAN 802.1Q ISL
Which of the following is the valid host range for the subnet on which the IP address 192.168.168.188 255.255.255.192 resides?
Which protocol is used to send a destination network unknown message back to originating hosts?
What does the passive command provide to dynamic routing protocols?
Which protocol does DHCP use at the Transport layer?
Which router command allows you to view the entire contents of all access lists?
Which command is used to determine if an IP access list is enabled on a particular interface?
How many broadcast domains are created when you segment a network with a 12-port switch?
Which command is used to upgrade an IOS on a Cisco router?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments