Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Networking
»
IPv6
To enable RIPng, which of the following would you use?
Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
Router1(config-if)# ipv6 router rip 1
Router1(config)# ipv6 router eigrp 10
Router1(config-rtr)# no shutdown
Router1(config-if)# ipv6 eigrp 10
Correct Answer:
Router1(config-if)# ipv6 router rip 1
Explanation:
It's pretty simple to enable RIPng for IPv6. You configure it right on the interface where you want RIP to run with the ipv6 router rip number command.
← Previous Question
Next Question→
More Questions from
IPv6
Which of the following is true when describing a global unicast address?
To enable OSPFv3, which of the following would you use?
What two multicast addresses does OSPFv3 use? FF02::A FF02::9 FF02::5 FF02::6
Which of the following is true when describing a multicast address?
You want to ping the loopback address of your local host(with IPv6). What will you type?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments