If your routing table has a static, a RIP, and an IGRP route to the same network, which route will be used to route packets by default?

Any available route
RIP route
Static route
IGRP route
They will all load-balance.

Correct Answer: Static route

Explanation:

Static routes have an administrative distance of 1 by default. Unless you change this, a static route will always be used over any other found route. IGRP has an administrative distance of 100, and RIP has an administrative distance of 120, by default.

Next Question→

More Questions from IP Routing

What command is used to stop RIP routing updates from exiting out an interface but still allow the interface to receive RIP route updates?
What is route poisoning?
Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network? Gateway(config)# ip route 0.0.0.0 0.0.0.0 206.143.5.2 Gateway(config)# router rip Gateway(config-router)# network 206.143.5.0 Gateway(config-router)# network 206.143.5.0 default
Which of the following is true regarding RIPv2?
What is split horizon?
You have the following routing table. Which of the following networks will not be placed in the neighbor routing table? R 192.168.30.0/24 [120/1] via 192.168.40.1, 00:00:12, Serial0 C 192.168.40.0/24 is directly connected, Serial0 172.16.0.0/24 is subnetted, 1 subnets C 172.16.30.0 is directly connected, Loopback0 R 192.168.20.0/24 [120/1] via 192.168.40.1, 00:00:12, Serial0 R 10.0.0.0/8 [120/15] via 192.168.40.1, 00:00:07, Serial0 C 192.168.50.0/24 is directly connected, Ethernet0
A network administrator views the output from the show ip route command. A network that is advertised by both RIP and IGRP appears in the routing table flagged as an IGRP route. Why is the RIP route to this network not used in the routing table?
Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?
Which two of the following are true regarding the distance-vector and link-state routing protocols? Link state sends its complete routing table out all active interfaces on periodic time intervals. Distance vector sends its complete routing table out all active interfaces on periodic time intervals. Link state sends updates containing the state of its own links to all routers in the internetwork. Distance vector sends updates containing the state of its own links to all routers in the internetwork.
You type debug ip rip on your router console and see that 172.16.10.0 is being advertised to you with a metric of 16. What does this mean?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion