The cross-section of a chisel is usually

More Questions from Workshop Technology

• A plug gauge is used to check the diameter of shafts and studs.
• The property of sand due to which it evolves a great amount of steam and other gases is called
• In back-hand welding, the angle between the welding torch and the work is kept as
• A saw which cuts wood during the return stroke of the saw is known as
• In sheet metal blanking, shear is provided on punches and dies so that
• The bloom is smaller than a billet.
• In shielded arc welding
• Surface plate is used to check the trueness of flat surfaces.
• The ferrous metals require more machining allowance than non-ferrous metals.
• In __________ welding, the weld may be made either from left to right or from right to left.

Discussion & Comments