Curioustab

Home » Mechanical Engineering » Steam Boilers and Engines

The cylindrical shell of a Lancashire boiler has diameter from

1 to 2 m
1.25 to 2.25 m
1.5 to 2.5 m
1.75 to 2.75 m

Correct Answer: 1.75 to 2.75 m

← Previous Question Next Question→

More Questions from Steam Boilers and Engines

The ratio of heat actually used in producing the steam to the heat liberated in the furnace, is known as
Willian's law states that the steam consumption per hour provided with a throttled governor is proportional to (where I.P. = Indicated power)
Which of the following boiler works on a forced circulation of water?
In a single acting steam engine
The diameter of internal flue tubes of a Lancashire boiler is about __________ that of its shell.
A compound steam engine in which piston rods of high pressure and low pressure cylinders are attached to two different cranks set at 90° to each other, is called
A throttle governed steam engine develops 15 kW with 280 kg per hour of steam and 35 kW with 520 kg per hour of steam. The steam consumption in kg per hour when developing 20 kW will be nearly
The capacity and working pressure.of a Cornish boiler is __________ as compared to Lancashire boiler.
When the circulation of water, in a boiler, is by convection currents which are set up during the heating of water, then the boiler is known as
The amount of water evaporated from feed water at __________ into dry and saturated steam at 100° C at normal atmospheric pressure is called equivalent evaporation from and at 100° C.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion