Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
In ultra-sonic machining, the metal is removed by
using abrasive slurry between the tool and work
direct contact of tool with the work
maintaining an electrolyte between the work and tool in a very small gap between the two
erosion caused by rapidly recurring spark discharges between the tool and work
Correct Answer:
using abrasive slurry between the tool and work
← Previous Question
Next Question→
More Questions from
Production Engineering
Gear lapping is an operation
In orthogonal cutting system, the maximum chip thickness occurs at the middle.
The facing is an operation of
Cemented carbide tool tips are produced by powder metallurgy.
The rake angle required to machine brass by high speed steel tool is
Which of the following statement is wrong about ultra-sonic machining?
When the cutting edge of the tool is dull, then during machining
The different spindle speeds on a lathe form
A single point thread cutting tool should ideally have
The angle included between the two lips projected upon a plane parallel to the drill axis and paralled to the two cutting lips, is called helix angle.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments