Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
The size of a lathe is specified by the
length between centres
swing diameter over the bed
swing diameter over the carriage
all of these
Correct Answer:
all of these
← Previous Question
Next Question→
More Questions from
Production Engineering
A drill mainly used in drilling brass, copper or softer materials, is
Flank wear occurs mainly on the
The hole drilled for tapping should be smaller than the tap size by twice the depth of thread.
Which of the following statement is wrong?
Slow speed of the spindle is necessary in
The tool life is affected by
In electro-discharge machining, tool is made of
The cutting speed is maximum while machining __________ with a high speed steel tool.
Relief angles on high speed steel tools usually vary from
The lip clearance angle is the angle formed by the
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments