The plunge grinding requires very __________ speed.

More Questions from Production Engineering

• The factor considered for evaluation of machinability is
• The lip clearance angle should decrease towards the centre of the drill than at the circumference.
• Tool life is measured by the
• Which of the following parameters govern the value of shear angle in continuous chip formation?
• For turning internal tapers, the suitable method is
• In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be
• The correct sequence of the following parameters in order of their maximum to minimum influence on tool life is
• For machining a cast iron workpiece by a high speed steel tool, the average cutting speed is
• An open structure of a grinding wheel is denoted by the number 1 to 8.
• Lathe bed is made of

Discussion & Comments