Curioustab

Home » Electronics » Time Response of Reactive Circuits

If the capacitor in an RC integrator shorts, the output

is at ground
would measure the same as the input
would measure zero volts
None of the above

Correct Answer: is at ground

← Previous Question Next Question→

More Questions from Time Response of Reactive Circuits

What voltage will the capacitor charge up to in the given circuit for the single input pulse shown?
In the given circuit, what must the pulse width and time between pulses be to allow the capacitor to completely charge by the end of each pulse and to completely discharge between each pulse?
If a periodic pulse waveform is applied to an RC differentiating circuit, which two conditions are possible?
How long will it take the capacitor in the given circuit to discharge?
An RL integrator and an RC differentiator can act as what types of filters, respectively?
What has the voltage across the resistor decayed to by the end of the pulse in the given circuit?
The output voltage of an RC integrator will eventually equal the voltage of a single input pulse if the input pulse width is less than 5 time constants.
A differentiator circuit can be used to convert a pulse input to a nearly constant dc output.
During the steady-state condition of a differentiator, the average output voltage is zero volts.
The voltage across a capacitor in an RC integrator circuit cannot change exponentially; it can change only instantaneously.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion