Discussion
Home ‣ Technical Drawing ‣ Computer Aided Design Basics Comments
- Question
You cannot use the Offset Tool to enlarge the size of a circle.
Options- A. True
- B. False
- Correct Answer
- False
- 1. Plastic pipe is lightweight and corrosionproof, but typically is not resistant to chemicals.
Options- A. True
- B. False Discuss
- 2. When dimensioning piping drawings, it is not necessary to indicate the size of each pipe.
Options- A. True
- B. False Discuss
- 3. Brass and copper pipe should be joined with fittings of copper-base alloy to avoid corrosion.
Options- A. True
- B. False Discuss
- 4. Brass and copper pipe is used in plumbing for supply, soil, waste, drain, and vent lines.
Options- A. True
- B. False Discuss
- 5. In a developed piping drawing, horizontal pipes may be revolved into the vertical plane so the entire installation can be shown on one plane.
Options- A. True
- B. False Discuss
- 6. The two principle components of a CAD system are the computer and the software used to create technical drawings.
Options- A. True
- B. False Discuss
- 7. UCS stands for User Coordinate System.
Options- A. True
- B. False Discuss
- 8. When beginning a new drawing in AutoCAD the default start-up layer will be the Defpoints layer.
Options- A. True
- B. False Discuss
- 9. The version of AutoCAD being used can be checked by reading top blue line or title bar located above the pull down menu bar.
Options- A. True
- B. False Discuss
- 10. In order to create a straight line in the AutoCAD graphics window the drafter is expected to pick a starting point and ending point.
Options- A. True
- B. False Discuss
Computer Aided Design Basics problems
Search Results
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.