Discussion
Home ‣ Technical Drawing ‣ Structural Drawing See What Others Are Saying!
- Question
Structural steel shop drawings are usually calculated to the nearest ½ inch.
Options- A. True
- B. False
- Correct Answer
- False
- 1. Axonometric, oblique, and perspective sketches show objects pictorially.
Options- A. True
- B. False Discuss
- 2. The meaning of each line on a technical drawing is indicated by its width and its particular line style.
Options- A. True
- B. False Discuss
- 3. Springs may be classified as either helical springs or flat springs.
Options- A. True
- B. False Discuss
- 4. A skeleton assembly can be used to define locations of individual parts in an assembly.
Options- A. True
- B. False Discuss
- 5. A freehand sketch should show attention to proportion, clarity, and correct line widths.
Options- A. True
- B. False Discuss
- 6. The dimensioning standards used by a typical architectural firm were probably developed by the architects, designers, and drafters in the firm.
Options- A. True
- B. False Discuss
- 7. Dimensioning to the edges of doors and windows is the preferred method by most architectural drafters.
Options- A. True
- B. False Discuss
- 8. Any principal view shows three of the four principal dimensions.
Options- A. True
- B. False Discuss
- 9. In working drawings with teeth cut to a standard shape, individual teeth typically are not shown.
Options- A. True
- B. False Discuss
- 10. A round is a rounded surface on the ________ corner of a part.
Options- A. inside
- B. outside
- C. radial
- D. isoplane Discuss
More questions
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: outside
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.