Discussion
Home ‣ Technical Drawing ‣ Oblique Projection Comments
- Question
Circles, circular arcs, and other curved surfaces may be drawn using offset measurements.
Options- A. True
- B. False
- Correct Answer
- True
- 1. In oblique projections, the projectors are perpendicular to each other but are not parallel to the plane of projection.
Options- A. True
- B. False Discuss
- 2. In CAD, oblique drawings are difficult to create because you cannot use snap increments or draw similarly to drawing on grid paper.
Options- A. True
- B. False Discuss
- 3. When the receding lines are drawn to half size, the drawing is known as a cabinet projection.
Options- A. True
- B. False Discuss
- 4. In oblique projections, one of the object's principal faces is parallel to the plane of projection.
Options- A. True
- B. False Discuss
- 5. In an oblique drawing, when an angle is specified in degrees in a receding plane, you should convert the angle into circular measurements.
Options- A. True
- B. False Discuss
- 6. ANSI/AGMA publishes detailed standards for gear design and drawings.
Options- A. True
- B. False Discuss
- 7. In working drawings for worm gears, gear teeth are omitted and the gear blank is represented conventionally.
Options- A. True
- B. False Discuss
- 8. When laying out a gear, the number of spaces should be twice the number of teeth.
Options- A. True
- B. False Discuss
- 9. Worm wheels are similar to helical gears cut to conform to the shape of the worm.
Options- A. True
- B. False Discuss
- 10. Proportions and shapes of gear teeth are not standardized.
Options- A. True
- B. False Discuss
Oblique Projection problems
Search Results
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.