logo

CuriousTab

CuriousTab

Discussion

Home ‣ Technical Drawing ‣ Oblique Projection Comments
  • Question

  • In an oblique drawing, when an angle is specified in degrees in a receding plane, you should convert the angle into circular measurements.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 

    • Oblique Projection problems

    Search Results

    • 1. If a complicated pictorial is needed, it may be easier and more accurate to create a 3D model than an oblique drawing.

    • Options
    • A. True
    • B. False
      • Discuss
    • 2. In general, all types of sections for isometric drawing may be applied to oblique drawing.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. If you are sketching an ellipse in an oblique drawing, you can block in the enclosing rectangle and sketch the ellipse tangent to its sides.

    • Options
    • A. True
    • B. False
      • Discuss
    • 4. Legal standards for how long engineering drawings need to be retained are standardized in the United States.

    • Options
    • A. True
    • B. False
      • Discuss
    • 5. It is important to establish a procedure and name files systematically.

    • Options
    • A. True
    • B. False
      • Discuss
    • 6. In oblique projections, one of the object's principal faces is parallel to the plane of projection.

    • Options
    • A. True
    • B. False
      • Discuss
    • 7. When the receding lines are drawn to half size, the drawing is known as a cabinet projection.

    • Options
    • A. True
    • B. False
      • Discuss
    • 8. In CAD, oblique drawings are difficult to create because you cannot use snap increments or draw similarly to drawing on grid paper.

    • Options
    • A. True
    • B. False
      • Discuss
    • 9. In oblique projections, the projectors are perpendicular to each other but are not parallel to the plane of projection.

    • Options
    • A. True
    • B. False
      • Discuss
    • 10. Circles, circular arcs, and other curved surfaces may be drawn using offset measurements.

    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.