Discussion
Home ‣ Technical Drawing ‣ Drawing Management See What Others Are Saying!
- Question
To be useful, drawings must be stored electronically in a manner that satisfies the requirements for a static snapshot of the design at the time of release.
Options- A. True
- B. False
- Correct Answer
- True
- 1. Proportions and shapes of gear teeth are not standardized.
Options- A. True
- B. False Discuss
- 2. Rapid prototyping costs about the same, but takes less time than traditional prototyping.
Options- A. True
- B. False Discuss
- 3. On electronic diagrams, it is typically not necessary to identify each separately replaceable part.
Options- A. True
- B. False Discuss
- 4. Tolerances in an architectural drawing are just as close as tolerances used in mechanical drawings.
Options- A. True
- B. False Discuss
- 5. Points may be represented by simple dots.
Options- A. True
- B. False Discuss
- 6. A fillet is a rounded surface on the ________ corner of a part.
Options- A. Inside
- B. outside
- C. radial
- D. isoplane Discuss
- 7. Any inclined surface can be shown in true shape when the appropriate auxiliary view is used.
Options- A. True
- B. False Discuss
- 8. A groove weld is a type of arc and gas weld.
Options- A. True
- B. False Discuss
- 9. Commonly, elevations are referenced to mean sea level.
Options- A. True
- B. False Discuss
- 10. Several of the tools used in traditional drafting include the following:
Options- A. Parallel straight edge
- B. 45 degree triangle
- C. Circle template
- D. All of the above Discuss
More questions
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: Inside
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: All of the above
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.