Discussion
Home ‣ Technical Drawing ‣ Threads, Fasteners and Springs Comments
- Question
The major diameter is the largest diameter of a screw thread.
Options- A. True
- B. False
- Correct Answer
- True
- 1. An internal thread is a thread on the outside of a member.
Options- A. True
- B. False Discuss
- 2. Rivets are not considered permanent fasteners.
Options- A. True
- B. False Discuss
- 3. Multiple threads are composed of one ridge, and the lead is equal to the pitch.
Options- A. True
- B. False Discuss
- 4. Pitch is equal to 12 divided by the number of threads per inch.
Options- A. True
- B. False Discuss
- 5. The form of a thread is the cross section of the thread cut by a plane containing the axis.
Options- A. True
- B. False Discuss
- 6. Electronic files for the most part have replaced the use of microfilm and microfiche.
Options- A. True
- B. False Discuss
- 7. Efficient document management is only a minor part of effective concurrent engineering practices.
Options- A. True
- B. False Discuss
- 8. Quality standards in some industries allow for electronic documents to serve as a permanent record if they are properly controlled.
Options- A. True
- B. False Discuss
- 9. After a drawing has been released, an engineering change order is used to document and approve drawing changes.
Options- A. True
- B. False Discuss
- 10. Because electronically stored files can easily be altered, they may not be considered acceptable for documentation.
Options- A. True
- B. False Discuss
Threads, Fasteners and Springs problems
Search Results
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.