Discussion
Home ‣ Technical Drawing ‣ Dimensioning Architectural Drawings Comments
- Question
Architectural dimensioning usually relies on tick marks or dots rather than arrow points.
Options- A. True
- B. False
- Correct Answer
- True
- 1. Drafters usually begin a set of dimensions from the inside edge of an exterior wall.
Options- A. True
- B. False Discuss
- 2. Dimensioning to the edges of doors and windows is the preferred method by most architectural drafters.
Options- A. True
- B. False Discuss
- 3. The total dimension of the front side should match the total dimension of the back side.
Options- A. True
- B. False Discuss
- 4. Architectural drafters are usually expected to place dimensions to the CAD standards established by the firm.
Options- A. True
- B. False Discuss
- 5. The dimensioning standards used by a typical architectural firm were probably developed by the architects, designers, and drafters in the firm.
Options- A. True
- B. False Discuss
- 6. Minor errors in dimensioning on an architectural drawing can result in major construction problems on the job site.
Options- A. True
- B. False Discuss
- 7. Tolerances in an architectural drawing are just as close as tolerances used in mechanical drawings.
Options- A. True
- B. False Discuss
- 8. The text style used on an architectural drawing is determined by the drafter.
Options- A. True
- B. False Discuss
- 9. A torsion spring is a type of helical spring.
Options- A. True
- B. False Discuss
- 10. Springs may be classified as either helical springs or flat springs.
Options- A. True
- B. False Discuss
Dimensioning Architectural Drawings problems
Search Results
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.