Discussion
Home ‣ Technical Drawing ‣ Auxiliary Views See What Others Are Saying!
- Question
The Offset tool is useful in setting up an auxiliary view.
Options- A. True
- B. False
- Correct Answer
- True
- 1. It is much easier for a drafter to use a CAD system rather than traditional board drawing because corrections are much easier to make.
Options- A. True
- B. False Discuss
- 2. Reference lines are always at right angles to the projection lines between the views.
Options- A. True
- B. False Discuss
- 3. An auxiliary view is used on technical drawings to project features on an inclined plane away from one of the primary views in such a way that features such as holes appear correctly.
Options- A. True
- B. False Discuss
- 4. Cams are used to produce regular repeating motions.
Options- A. True
- B. False Discuss
- 5. It is not always possible to show all of the drawing views in alignment on a sheet.
Options- A. True
- B. False Discuss
- 6. If you are sketching an ellipse in an oblique drawing, you can block in the enclosing rectangle and sketch the ellipse tangent to its sides.
Options- A. True
- B. False Discuss
- 7. If the roof pitch for a house is identified as 5/12 the height of the roof rises 2 ½" for every 14" of horizontal run.
Options- A. True
- B. False Discuss
- 8. A half-moon protractor is divided into how many degrees?
Options- A. 360
- B. 180
- C. 270
- D. 310 Discuss
- 9. Right-hand and left-hand parts are mirror images and are made to be interchangeable.
Options- A. True
- B. False Discuss
- 10. When dimensioning piping drawings, it is not necessary to indicate the size of each pipe.
Options- A. True
- B. False Discuss
More questions
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: 180
Correct Answer: False
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.