Discussion
Home ‣ Technical Drawing ‣ 2D Drawing Representation Comments
- Question
A plane surface cannot intersect or be tangent to a contoured surface.
Options- A. True
- B. False
- Correct Answer
- False
- 1. A boss is a short raised protrusion above the surface of a part.
Options- A. True
- B. False Discuss
- 2. If a plane intersects a contoured surface, no line is drawn to represent the edge.
Options- A. True
- B. False Discuss
- 3. Simplified conventional representations that deviate from true orthographic projection may be used to enhance economy and clarity in a drawing.
Options- A. True
- B. False Discuss
- 4. When a curved surface intersects a plane surface, an edge is formed.
Options- A. True
- B. False Discuss
- 5. A counterbore is a cylindrical recess around a hole, usually to receive a bolt head or nut.
Options- A. True
- B. False Discuss
- 6. A lug is a flattened collar or rim around a cylindrical part to allow for attachment.
Options- A. True
- B. False Discuss
- 7. Knurl is a pattern form on a surface to provide for better gripping or more surface area for attachment.
Options- A. True
- B. False Discuss
- 8. A fillet is a rounded exterior blend between surfaces.
Options- A. True
- B. False Discuss
- 9. A secondary view is always perpendicular to one of the principal views.
Options- A. True
- B. False Discuss
- 10. Measurements are always made at right angles to the reference lines or parallel to the projection lines.
Options- A. True
- B. False Discuss
2D Drawing Representation problems
Search Results
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: True
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.