Discussion
Home ‣ Technical Drawing ‣ 2D Drawing Representation Comments
- Question
A counterbore is a cylindrical recess around a hole, usually to receive a bolt head or nut.
Options- A. True
- B. False
- Correct Answer
- True
- 1. Right-hand and left-hand parts are mirror images and are made to be interchangeable.
Options- A. True
- B. False Discuss
- 2. It is not always possible to show all of the drawing views in alignment on a sheet.
Options- A. True
- B. False Discuss
- 3. Small curves called runouts are used to represent fillets that connect with plane surfaces tangent to cylinders.
Options- A. True
- B. False Discuss
- 4. A keyway is a small groove cut around the diameter of a cylinder, often where it changes diameter.
Options- A. True
- B. False Discuss
- 5. A polygon is a planar area that is enclosed by either angular or curved lines.
Options- A. True
- B. False Discuss
- 6. When a curved surface intersects a plane surface, an edge is formed.
Options- A. True
- B. False Discuss
- 7. Simplified conventional representations that deviate from true orthographic projection may be used to enhance economy and clarity in a drawing.
Options- A. True
- B. False Discuss
- 8. If a plane intersects a contoured surface, no line is drawn to represent the edge.
Options- A. True
- B. False Discuss
- 9. A boss is a short raised protrusion above the surface of a part.
Options- A. True
- B. False Discuss
- 10. A plane surface cannot intersect or be tangent to a contoured surface.
Options- A. True
- B. False Discuss
2D Drawing Representation problems
Search Results
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.