logo

CuriousTab

CuriousTab

Discussion

Home ‣ Technical Drawing ‣ Isometric Drawings Comments
  • Question

  • By using the F-5 key you can switch from ISO Right to ISO Top to ISO Back.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 

    • Isometric Drawings problems

    Search Results

    • 1. When creating a circle on an isometric flat surface you need to use the circle tool.

    • Options
    • A. True
    • B. False
      • Discuss
    • 2. When using AutoCAD to create an isometric drawing it is best to set the grid to ISO.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. The primary difference between isometric drawings and perspective drawings is that in an isometric drawing both vertical and horizontal lines remain parallel while in a perspective drawing both horizontal and vertical lines are in line with an apparent vanishing point.

    • Options
    • A. True
    • B. False
      • Discuss
    • 4. In an isometric drawing all horizontal lines are drawn on a 60 degree angle away from a given point.

    • Options
    • A. True
    • B. False
      • Discuss
    • 5. The AutoCAD Center Mark tool can be used in an isometric drawing as you would use it in any conventional orthographic drawing.

    • Options
    • A. True
    • B. False
      • Discuss
    • 6. An assembly drawing is intended to illustrate a single mechanical part.

    • Options
    • A. True
    • B. False
      • Discuss
    • 7. Mechanical drafters can revise any drawing at any time without tracking those changes.

    • Options
    • A. True
    • B. False
      • Discuss
    • 8. Designers utilize several methods for solving mechanical design problems including brainstorming ideas.

    • Options
    • A. True
    • B. False
      • Discuss
    • 9. A detail drawing of a part is intended to provide the necessary information needed to fabricate that part.

    • Options
    • A. True
    • B. False
      • Discuss
    • 10. The mechanical engineering industry relies on complex mechanical drawings that are often referred to as working drawings.

    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.