Discussion
Home ‣ Technical Drawing ‣ Tolerancing Comments
- Question
Allowance is the maximum clearance or minimum interference specified to achieve a fit between two mating parts.
Options- A. True
- B. False
- Correct Answer
- False
- 1. Unilateral tolerances have traditionally been given on angles.
Options- A. True
- B. False Discuss
- 2. A heavy straight line should be drawn under all dimension values that are to scale.
Options- A. True
- B. False Discuss
- 3. The nominal size of a feature is the exact measurement of the feature after the tolerance has been applied to it.
Options- A. True
- B. False Discuss
- 4. A metric dimension that is a whole number does not show a decimal point or a zero.
Options- A. True
- B. False Discuss
- 5. Drawings are usually made to a scale, which is indicated in the title block.
Options- A. True
- B. False Discuss
- 6. Implied 90 degree angles typically have different general tolerances applied to them than other angles covered by a general note.
Options- A. True
- B. False Discuss
- 7. Nominal size is used for general identification and is usually expressed in decimals.
Options- A. True
- B. False Discuss
- 8. Tolerances of form and position are typically not used to control straightness.
Options- A. True
- B. False Discuss
- 9. Defining the datum reference frame is necessary to apply GDT principles.
Options- A. True
- B. False Discuss
- 10. Datum surfaces and features are used as references to control other features.
Options- A. True
- B. False Discuss
Tolerancing problems
Search Results
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.