logo

CuriousTab

CuriousTab

Discussion


Home Technical Drawing Dimensioning Comments

  • Question
  • Fillet radii can be given in a general note.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • True 


  • Dimensioning problems


    Search Results


    • 1. The American Society of Mechanical Engineers provides a set of common standards used by industry for placement of dimensions.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. When a finished part is measured, it may vary slightly from the exact dimension specified.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. A set of two mutually perpendicular datum planes is required for coordinate dimensioning.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. Typically, all dimension values and notes are lettered horizontally and should read from the bottom of the sheet.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. Most mechanical drawings will include tolerance information in or near the drawing title block.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. It is permissible to letter a dimension value over any line on the drawing.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. Although an engineer has placed dimensions in specific locations the drafter has the freedom to arrange them as he deems necessary.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. In a group of parallel dimension lines, the dimension values should be staggered.

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. By adding dimensions to a technical drawing the drafter is providing information about the size and location of features of a part.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. Dimensions are given in the form of distances, angles, and notes only when using metric units.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment