Discussion
Home ‣ Technical Drawing ‣ Dimensioning Comments
- Question
A set of two mutually perpendicular datum planes is required for coordinate dimensioning.
Options- A. True
- B. False
- Correct Answer
- False
- 1. Typically, all dimension values and notes are lettered horizontally and should read from the bottom of the sheet.
Options- A. True
- B. False Discuss
- 2. Most mechanical drawings will include tolerance information in or near the drawing title block.
Options- A. True
- B. False Discuss
- 3. Avoid dimensioning to hidden lines.
Options- A. True
- B. False Discuss
- 4. Longer dimension lines are nearest the object outline.
Options- A. True
- B. False Discuss
- 5. It is more difficult to manufacture a part designed using two decimal places than the same part using four decimal places.
Options- A. True
- B. False Discuss
- 6. When a finished part is measured, it may vary slightly from the exact dimension specified.
Options- A. True
- B. False Discuss
- 7. The American Society of Mechanical Engineers provides a set of common standards used by industry for placement of dimensions.
Options- A. True
- B. False Discuss
- 8. Fillet radii can be given in a general note.
Options- A. True
- B. False Discuss
- 9. It is permissible to letter a dimension value over any line on the drawing.
Options- A. True
- B. False Discuss
- 10. Although an engineer has placed dimensions in specific locations the drafter has the freedom to arrange them as he deems necessary.
Options- A. True
- B. False Discuss
Dimensioning problems
Search Results
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.