Discussion
Home ‣ Technical Drawing ‣ Dimensioning Comments
- Question
Longer dimension lines are nearest the object outline.
Options- A. True
- B. False
- Correct Answer
- False
- 1. It is more difficult to manufacture a part designed using two decimal places than the same part using four decimal places.
Options- A. True
- B. False Discuss
- 2. The inch is the commonly used unit for most metric engineering drawings.
Options- A. True
- B. False Discuss
- 3. Where the decimal-inch dimension is used, a zero is not used before the decimal point of values less than 1.
Options- A. True
- B. False Discuss
- 4. When extension lines or centerlines cross visible object lines, gaps should not be left in the lines.
Options- A. True
- B. False Discuss
- 5. The drafter should always try to dimension to the profile view of an object when possible.
Options- A. True
- B. False Discuss
- 6. Avoid dimensioning to hidden lines.
Options- A. True
- B. False Discuss
- 7. Most mechanical drawings will include tolerance information in or near the drawing title block.
Options- A. True
- B. False Discuss
- 8. Typically, all dimension values and notes are lettered horizontally and should read from the bottom of the sheet.
Options- A. True
- B. False Discuss
- 9. A set of two mutually perpendicular datum planes is required for coordinate dimensioning.
Options- A. True
- B. False Discuss
- 10. When a finished part is measured, it may vary slightly from the exact dimension specified.
Options- A. True
- B. False Discuss
Dimensioning problems
Search Results
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.