logo

CuriousTab

CuriousTab

Discussion


Home Technical Drawing Dimensioning Comments

  • Question
  • The inch is the commonly used unit for most metric engineering drawings.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 


  • Dimensioning problems


    Search Results


    • 1. Where the decimal-inch dimension is used, a zero is not used before the decimal point of values less than 1.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. When extension lines or centerlines cross visible object lines, gaps should not be left in the lines.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. The drafter should always try to dimension to the profile view of an object when possible.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. Dimension lines should not cross extension lines.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. When designing mechanical devices, the designer must consider what the allowable variation in size between mating parts can be.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. It is more difficult to manufacture a part designed using two decimal places than the same part using four decimal places.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. Longer dimension lines are nearest the object outline.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. Avoid dimensioning to hidden lines.

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. Most mechanical drawings will include tolerance information in or near the drawing title block.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. Typically, all dimension values and notes are lettered horizontally and should read from the bottom of the sheet.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment