Discussion
Home ‣ Technical Drawing ‣ Dimensioning Comments
- Question
Where the decimal-inch dimension is used, a zero is not used before the decimal point of values less than 1.
Options- A. True
- B. False
- Correct Answer
- True
- 1. When extension lines or centerlines cross visible object lines, gaps should not be left in the lines.
Options- A. True
- B. False Discuss
- 2. The drafter should always try to dimension to the profile view of an object when possible.
Options- A. True
- B. False Discuss
- 3. Dimension lines should not cross extension lines.
Options- A. True
- B. False Discuss
- 4. When designing mechanical devices, the designer must consider what the allowable variation in size between mating parts can be.
Options- A. True
- B. False Discuss
- 5. An extension line is a thin, dark, solid line that extends from a point on the drawing to which a dimension refers.
Options- A. True
- B. False Discuss
- 6. The inch is the commonly used unit for most metric engineering drawings.
Options- A. True
- B. False Discuss
- 7. It is more difficult to manufacture a part designed using two decimal places than the same part using four decimal places.
Options- A. True
- B. False Discuss
- 8. Longer dimension lines are nearest the object outline.
Options- A. True
- B. False Discuss
- 9. Avoid dimensioning to hidden lines.
Options- A. True
- B. False Discuss
- 10. Most mechanical drawings will include tolerance information in or near the drawing title block.
Options- A. True
- B. False Discuss
Dimensioning problems
Search Results
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.