Discussion
Home ‣ Technical Drawing ‣ Multiview Drawing See What Others Are Saying!
- Question
If technical drawings are used to communicate size and shape descriptions, it is not important to worry about either the weight of a line or the type of line being used.
Options- A. True
- B. False
- Correct Answer
- False
- 1. In working drawings with teeth cut to a standard shape, individual teeth typically are not shown.
Options- A. True
- B. False Discuss
- 2. A round is a rounded surface on the ________ corner of a part.
Options- A. inside
- B. outside
- C. radial
- D. isoplane Discuss
- 3. An edge is formed where two surfaces intersect.
Options- A. True
- B. False Discuss
- 4. Allowance is the maximum clearance or minimum interference specified to achieve a fit between two mating parts.
Options- A. True
- B. False Discuss
- 5. Isometric drawings, unlike isometric projections, are drawn using the full length measurements of the actual drawing and lack foreshortening.
Options- A. True
- B. False Discuss
- 6. Perspective drawings are the least time-consuming types of pictorials to draw by hand.
Options- A. True
- B. False Discuss
- 7. The ________ dimension tool will place the length of an angled line.
Options- A. Aligned
- B. Angle
- C. Linear
- D. Radial Discuss
- 8. Short dashed lines can be used to illustrate a visible feature.
Options- A. True
- B. False Discuss
- 9. Tolerance issues are primarily a concern in manufacturing rather than in the design and drafting process.
Options- A. True
- B. False Discuss
- 10. The position of the observer's eye is called the station point.
Options- A. True
- B. False Discuss
More questions
Correct Answer: True
Correct Answer: outside
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: Aligned
Correct Answer: False
Correct Answer: False
Correct Answer: True
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.