Discussion
Home ‣ Technical Drawing ‣ Sectional Views Comments
- Question
The visible edges of the object behind the cutting plane are not cross-hatched.
Options- A. True
- B. False
- Correct Answer
- True
- 1. In offset sections, the bends in the cutting plane are typically shown in the sectional view.
Options- A. True
- B. False Discuss
- 2. The angle of revolution should always be less than 45 degrees for an aligned section.
Options- A. True
- B. False Discuss
- 3. The preferred cutting plane line style is made up of equal dashes ending in arrowheads.
Options- A. True
- B. False Discuss
- 4. Quarter sections expose the interior of one half of the object and the exterior of the other half.
Options- A. True
- B. False Discuss
- 5. Removed sections should be labeled and arranged in order from right to left.
Options- A. True
- B. False Discuss
- 6. The arrow points on either end of a Cutting Plane line indicate the direction of view.
Options- A. True
- B. False Discuss
- 7. Section views cannot replace the normal top, front, side, or other standard orthographic views.
Options- A. True
- B. False Discuss
- 8. Hidden lines are typically included in section views.
Options- A. True
- B. False Discuss
- 9. The cutting plane is shown in a view adjacent to the sectional view.
Options- A. True
- B. False Discuss
- 10. If technical drawings are used to communicate size and shape descriptions, it is not important to worry about either the weight of a line or the type of line being used.
Options- A. True
- B. False Discuss
Sectional Views problems
Search Results
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.