logo

CuriousTab

CuriousTab

Discussion

Home ‣ Technical Drawing ‣ Sectional Views Comments
  • Question

  • Removed sections should be labeled and arranged in order from right to left.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 

    • Sectional Views problems

    Search Results

    • 1. A section-lined area is always completely bounded by a visible outline.

    • Options
    • A. True
    • B. False
      • Discuss
    • 2. If you set the ANSI 131 hatch pattern to an angle of 45 degrees the lines will be placed vertically.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. Omit hidden lines from both halves of a half section whenever possible.

    • Options
    • A. True
    • B. False
      • Discuss
    • 4. The Cutting Plane line reveals the type of material that the object is to be made from.

    • Options
    • A. True
    • B. False
      • Discuss
    • 5. The section lines in all hatched areas for an object must be parallel.

    • Options
    • A. True
    • B. False
      • Discuss
    • 6. Quarter sections expose the interior of one half of the object and the exterior of the other half.

    • Options
    • A. True
    • B. False
      • Discuss
    • 7. The preferred cutting plane line style is made up of equal dashes ending in arrowheads.

    • Options
    • A. True
    • B. False
      • Discuss
    • 8. The angle of revolution should always be less than 45 degrees for an aligned section.

    • Options
    • A. True
    • B. False
      • Discuss
    • 9. In offset sections, the bends in the cutting plane are typically shown in the sectional view.

    • Options
    • A. True
    • B. False
      • Discuss
    • 10. The visible edges of the object behind the cutting plane are not cross-hatched.

    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.