Discussion
Home ‣ Technical Drawing ‣ Sectional Views Comments
- Question
When a part is cut fully in half, the resulting view is called a half section.
Options- A. True
- B. False
- Correct Answer
- False
- 1. One of the outcomes of using section views in a technical drawing is the elimination of hidden lines.
Options- A. True
- B. False Discuss
- 2. The Cutting Plane line should be displayed at the same line weight as object lines.
Options- A. True
- B. False Discuss
- 3. In AutoCAD the Hatch tool is used to designate what pattern is to be used for a section view.
Options- A. True
- B. False Discuss
- 4. It is not acceptable to use the general-purpose symbol at different angles for different parts.
Options- A. True
- B. False Discuss
- 5. When a cutting plane line would obscure important details, just the ends of the line outside the view and the arrows can be shown.
Options- A. True
- B. False Discuss
- 6. The ANSI 131 hatch pattern is the AutoCAD default hatch pattern.
Options- A. True
- B. False Discuss
- 7. The section lines in all hatched areas for an object must be parallel.
Options- A. True
- B. False Discuss
- 8. The Cutting Plane line reveals the type of material that the object is to be made from.
Options- A. True
- B. False Discuss
- 9. Omit hidden lines from both halves of a half section whenever possible.
Options- A. True
- B. False Discuss
- 10. If you set the ANSI 131 hatch pattern to an angle of 45 degrees the lines will be placed vertically.
Options- A. True
- B. False Discuss
Sectional Views problems
Search Results
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.