Discussion
Home ‣ Technical Drawing ‣ Sectional Views See What Others Are Saying!
- Question
It is not acceptable to use the general-purpose symbol at different angles for different parts.
Options- A. True
- B. False
- Correct Answer
- False
- 1. Quarter sections expose the interior of one half of the object and the exterior of the other half.
Options- A. True
- B. False Discuss
- 2. This type of solid has a polygon for a base and triangular lateral faces that intersect at a vertex:
Options- A. Pyramid
- B. Prism
- C. Cone
- D. Torus Discuss
- 3. The form of a thread is the cross section of the thread cut by a plane containing the axis.
Options- A. True
- B. False Discuss
- 4. The union command only works on 2-dimensional objects.
Options- A. True
- B. False Discuss
- 5. With regard to lettering, the shapes of letters are not described as part of drawing standards.
Options- A. True
- B. False Discuss
- 6. The rear, left-side, front, and right-side views align horizontally.
Options- A. True
- B. False Discuss
- 7. Traditional, sequential engineering design is a logical approach, but in practice it can often be wasteful.
Options- A. True
- B. False Discuss
- 8. On a floor plan the dashed line that appears approximately 24" outside the exterior wall represents the ________.
Options- A. sidewalk
- B. roof overhang
- C. plumbing drain lines
- D. none of the above Discuss
- 9. The text height for room names should be set to ________for a drawing that will be plotted to a scale of ¼" = 1'-0".
Options- A. 4"
- B. 5"
- C. 6"
- D. 8" Discuss
- 10. Reinforced concrete has embedded steel reinforcing bars.
Options- A. True
- B. False Discuss
More questions
Correct Answer: False
Correct Answer: Pyramid
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: roof overhang
Correct Answer: 6"
Correct Answer: True
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.