logo

CuriousTab

CuriousTab

Discussion

Home ‣ Technical Drawing ‣ Blocks See What Others Are Saying!
  • Question

  • When creating your own blocks it is important to avoid drawing any portion of the block in the ________ layer.


  • Options
  • A. 0
  • B. center line
  • C. hatch
  • D. hidden line

  • Correct Answer
  • 0 

    • More questions

    • 1. Revolution is a method of determining the true length and true size of inclined and oblique lines and planes.

    • Options
    • A. True
    • B. False
      • Discuss
    • 2. If technical drawings are used to communicate size and shape descriptions, it is not important to worry about either the weight of a line or the type of line being used.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. Drafters usually work alone in their cubical without any interaction with other drafters, designers, architects, or engineers.

    • Options
    • A. True
    • B. False
      • Discuss
    • 4. Monuments marking surveying points are typically not intended to be permanent.

    • Options
    • A. True
    • B. False
      • Discuss
    • 5. Plastic pipe is lightweight and corrosionproof, but typically is not resistant to chemicals.

    • Options
    • A. True
    • B. False
      • Discuss
    • 6. The Offset command can be used on vertical lines but not on horizontal lines.

    • Options
    • A. True
    • B. False
      • Discuss
    • 7. The primary difference between isometric drawings and perspective drawings is that in an isometric drawing both vertical and horizontal lines remain parallel while in a perspective drawing both horizontal and vertical lines are in line with an apparent vanishing point.

    • Options
    • A. True
    • B. False
      • Discuss
    • 8. The center line of a hidden cylinder feature appearing in the front view should line up with the center mark in the corresponding circle which appears in the auxiliary view.

    • Options
    • A. True
    • B. False
      • Discuss
    • 9. When dimensioning piping drawings, you give the lengths of all runs of this type:

    • Options
    • A. Straight
    • B. Angular
    • C. Filleted
    • D. Transverse
      • Discuss
    • 10. In working drawings for worm gears, gear teeth are omitted and the gear blank is represented conventionally.

    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.