Discussion
Home ‣ Technical Drawing ‣ Computer Aided Design Basics See What Others Are Saying!
- Question
When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.
Options- A. pull the line from away from the starting point very carefully
- B. insure that Ortho is on
- C. enter 3 for the length of the line
- D. read the coordinate position on the Dynamic Readout
- Correct Answer
- insure that Ortho is on
- 1. In a group of parallel dimension lines, the dimension values should be staggered.
Options- A. True
- B. False Discuss
- 2. Scale is stated as a ratio of the number of drawing units to the number of actual units.
Options- A. True
- B. False Discuss
- 3. Working drawings are a set of assembly and detail drawings.
Options- A. True
- B. False Discuss
- 4. When the receding lines are drawn to half size, the drawing is known as a cabinet projection.
Options- A. True
- B. False Discuss
- 5. Visible lines always take precedence over hidden lines or centerlines.
Options- A. True
- B. False Discuss
- 6. The ISO has its own system of preferred metric limits and fits.
Options- A. True
- B. False Discuss
- 7. CAD component layout programs allow you to create the best possible parts placement.
Options- A. True
- B. False Discuss
- 8. The pattern used for hatching a section can be something other than diagonal lines.
Options- A. True
- B. False Discuss
- 9. The inch is the commonly used unit for most metric engineering drawings.
Options- A. True
- B. False Discuss
- 10. Graphic representation has developed along two distinct lines, engineering and technical.
Options- A. True
- B. False Discuss
More questions
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.