Discussion
Home ‣ Technical Drawing ‣ Computer Aided Design Basics See What Others Are Saying!
- Question
Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________.
Options- A. type @3<45 and enter
- B. type 3 back slash and enter
- C. type 3 forward slash and enter
- D. type 3 and try to use the Dynamic Input readout to find the end point
- Correct Answer
- type @3<45 and enter
- 1. PVC joints are made with flared joints or solder joints.
Options- A. True
- B. False Discuss
- 2. Teeth are spaced by laying out equal angles.
Options- A. True
- B. False Discuss
- 3. All professional engineers are good CAD drafters.
Options- A. True
- B. False Discuss
- 4. In AutoCAD a block is a symbol or object that can be inserted into a drawing.
Options- A. True
- B. False Discuss
- 5. Type of weld is typically not specified on the welding symbol.
Options- A. True
- B. False Discuss
- 6. Hidden lines are typically included in section views.
Options- A. True
- B. False Discuss
- 7. Piping may also be shown in orthographic projection.
Options- A. True
- B. False Discuss
- 8. Generally, hidden lines should be omitted in auxiliary views.
Options- A. True
- B. False Discuss
- 9. This type of pipe is commonly used for water or gas service, and also as soil pipe:
Options- A. PVC
- B. Copper
- C. Steel
- D. Cast-iron Discuss
- 10. When creating a block the drafter should carefully draw it in the 0 layer.
Options- A. True
- B. False Discuss
More questions
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: Cast-iron
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.