logo

CuriousTab

CuriousTab

Discussion

Home ‣ Technical Drawing ‣ Piping Drawings Comments
  • Question

  • This type of drawing shows two lines representing the pipe diameter:


  • Options
  • A. Single-line
  • B. Double-line
  • C. Standard piping
  • D. Centerline piping

  • Correct Answer
  • Double-line 

    • Piping Drawings problems

    Search Results

    • 1. These types of pipes are generally connected with bell and spigot joints or flanged joints:

    • Options
    • A. Soil and waste
    • B. Water and gas
    • C. Water and steam
    • D. Gas and soil
      • Discuss
    • 2. This type of pipe is commonly used for water, steam, oil, and gas:

    • Options
    • A. Wrought iron or copper
    • B. PVC or steel
    • C. Steel or wrought iron
    • D. Copper or PVC
      • Discuss
    • 3. This type of structural steel drawing shows all dimensions necessary for fabrication:

    • Options
    • A. Shop drawings
    • B. Design drawings
    • C. Weldment drawings
    • D. Application drawings
      • Discuss
    • 4. This type of weld is the most common in structural steel fabrication:

    • Options
    • A. Fillet weld
    • B. Beam weld
    • C. Rivet weld
    • D. Structural weld
      • Discuss
    • 5. In this type of concrete, the steel is pretensioned before the superimposed load is applied:

    • Options
    • A. Aggregate
    • B. Prestressed
    • C. Reinforced
    • D. Preloaded
      • Discuss
    • 6. This type of pipe is commonly used for water or gas service, and also as soil pipe:

    • Options
    • A. PVC
    • B. Copper
    • C. Steel
    • D. Cast-iron
      • Discuss
    • 7. When dimensioning piping drawings, you give the lengths of all runs of this type:

    • Options
    • A. Straight
    • B. Angular
    • C. Filleted
    • D. Transverse
      • Discuss
    • 8. This is used in applications for nonferrous construction:

    • Options
    • A. Copper tubing
    • B. Steel pipe
    • C. PVC pipe
    • D. Iron tubing
      • Discuss
    • 9. In this type of drawing, vertical pipes may be revolved into the horizontal plane:

    • Options
    • A. Standard view
    • B. Elevation view
    • C. Transverse piping
    • D. Developed piping
      • Discuss
    • 10. A line with a tapering width can be easily created by using the ________ tool.

    • Options
    • A. circle
    • B. eclipse
    • C. line
    • D. polyline
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.