logo

CuriousTab

CuriousTab

Discussion


Home Technical Drawing Auxiliary Views Comments

  • Question
  • This type of solid is formed by sweeping a shape along a linear path:


  • Options
  • A. Planar solid
  • B. Revolved solid
  • C. Warped solid
  • D. Extruded solid

  • Correct Answer
  • Extruded solid 


  • Auxiliary Views problems


    Search Results


    • 1. When using the descriptive geometry method to create an auxiliary view the drafter should ________.

    • Options
    • A. rotate the snap grid to the same angle of the inclined plane
    • B. offset the right vertical line of the front view
    • C. rotate the top line of the front view 45 degrees
    • D. offset the top line of the front view 2 inches
    • Discuss
    • 2. The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.

    • Options
    • A. Width
    • B. height
    • C. length
    • D. none of the above
    • Discuss
    • 3. The lines used to create the auxiliary view should appear as ________ in the finished view.

    • Options
    • A. Object lines
    • B. Construction lines
    • C. Reference lines
    • D. Construction lines
    • Discuss
    • 4. A partial auxiliary view usually shows only features on the ________ of the inclined line and not any projection of other planes.

    • Options
    • A. hidden lines
    • B. plane
    • C. center lines
    • D. none of the above
    • Discuss
    • 5. An efficient method for trimming the corners on an auxiliary view is to use the ________.

    • Options
    • A. 0 radius fillet
    • B. Hatch tool
    • C. Extend tool
    • D. Grips function
    • Discuss
    • 6. A secondary auxiliary view is a projection off of the ________.

    • Options
    • A. Front view
    • B. Top view
    • C. Primary auxiliary view
    • D. None of the above
    • Discuss
    • 7. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.

    • Options
    • A. Linear dimension
    • B. Aligned dimension
    • C. Baseline dimension
    • D. Angle dimension
    • Discuss
    • 8. In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:

    • Options
    • A. Primary
    • B. Secondary
    • C. Revolved
    • D. Partial
    • Discuss
    • 9. Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:

    • Options
    • A. Circular
    • B. Elliptical
    • C. Lengthened
    • D. Angular
    • Discuss
    • 10. Approximately this much of the cost of product development and manufacture is determined at the design stage:

    • Options
    • A. 40-50%
    • B. 60-75%
    • C. 70-80%
    • D. 75-85%
    • Discuss


    Comments

    There are no comments.

Enter a new Comment