Discussion
Home ‣ Technical Drawing ‣ Auxiliary Views Comments
- Question
The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.
Options- A. Width
- B. height
- C. length
- D. none of the above
- Correct Answer
- Width
- 1. The lines used to create the auxiliary view should appear as ________ in the finished view.
Options- A. Object lines
- B. Construction lines
- C. Reference lines
- D. Construction lines Discuss
- 2. A partial auxiliary view usually shows only features on the ________ of the inclined line and not any projection of other planes.
Options- A. hidden lines
- B. plane
- C. center lines
- D. none of the above Discuss
- 3. An efficient method for trimming the corners on an auxiliary view is to use the ________.
Options- A. 0 radius fillet
- B. Hatch tool
- C. Extend tool
- D. Grips function Discuss
- 4. In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:
Options- A. Removed section
- B. Revolved section
- C. Auxiliary section
- D. Partial section Discuss
- 5. The principle views associated with orthographic projection are ________.
Options- A. Front view
- B. Right side view
- C. Top view
- D. All of the above Discuss
- 6. When using the descriptive geometry method to create an auxiliary view the drafter should ________.
Options- A. rotate the snap grid to the same angle of the inclined plane
- B. offset the right vertical line of the front view
- C. rotate the top line of the front view 45 degrees
- D. offset the top line of the front view 2 inches Discuss
- 7. This type of solid is formed by sweeping a shape along a linear path:
Options- A. Planar solid
- B. Revolved solid
- C. Warped solid
- D. Extruded solid Discuss
- 8. A secondary auxiliary view is a projection off of the ________.
Options- A. Front view
- B. Top view
- C. Primary auxiliary view
- D. None of the above Discuss
- 9. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
Options- A. Linear dimension
- B. Aligned dimension
- C. Baseline dimension
- D. Angle dimension Discuss
- 10. In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
Options- A. Primary
- B. Secondary
- C. Revolved
- D. Partial Discuss
Auxiliary Views problems
Search Results
Correct Answer: Object lines
Correct Answer: plane
Correct Answer: 0 radius fillet
Correct Answer: Auxiliary section
Correct Answer: All of the above
Correct Answer: rotate the snap grid to the same angle of the inclined plane
Correct Answer: Extruded solid
Correct Answer: Primary auxiliary view
Correct Answer: Aligned dimension
Correct Answer: Partial
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.