Discussion
Home ‣ Technical Drawing ‣ Auxiliary Views Comments
- Question
This is the most common application for developments and intersections:
Options- A. Sheet metal construction
- B. Piping
- C. Architecture
- D. Mechanical engineering
- Correct Answer
- Sheet metal construction
- 1. A partial auxiliary view is used to show only the ________ in the auxiliary view.
Options- A. projected inclined plane
- B. the projected top view
- C. the projected side view
- D. none of the above Discuss
- 2. This type of surface may be a plane, a single curved surface, or a warped surface:
Options- A. Edge surface
- B. Ruled surface
- C. Auxiliary surface
- D. Developed surface Discuss
- 3. The principle reason for using an auxiliary view is ________.
Options- A. to eliminate hidden lines
- B. to create a true projection plane from an inclined plane in one of the primary views
- C. to show cylinders as ellipses
- D. to locate center marks Discuss
- 4. This is a hollow cylinder that is often used as a protective sleeve or guide or as a bearing:
Options- A. Lug
- B. Bushing
- C. Chamfer
- D. Knurl Discuss
- 5. This is a flat or rounded tab protruding from a surface, usually to provide a method for attachment:
Options- A. Lug
- B. Boss
- C. Chamfer
- D. Spotface Discuss
- 6. This type of auxiliary view is projected onto a plane that is perpendicular to one of the principal planes of projection:
Options- A. Primary
- B. Secondary
- C. Revolved
- D. Successive Discuss
- 7. The principle views associated with orthographic projection are ________.
Options- A. Front view
- B. Right side view
- C. Top view
- D. All of the above Discuss
- 8. In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:
Options- A. Removed section
- B. Revolved section
- C. Auxiliary section
- D. Partial section Discuss
- 9. An efficient method for trimming the corners on an auxiliary view is to use the ________.
Options- A. 0 radius fillet
- B. Hatch tool
- C. Extend tool
- D. Grips function Discuss
- 10. A partial auxiliary view usually shows only features on the ________ of the inclined line and not any projection of other planes.
Options- A. hidden lines
- B. plane
- C. center lines
- D. none of the above Discuss
Auxiliary Views problems
Search Results
Correct Answer: projected inclined plane
Correct Answer: Ruled surface
Correct Answer: to create a true projection plane from an inclined plane in one of the primary views
Correct Answer: Bushing
Correct Answer: Lug
Correct Answer: Primary
Correct Answer: All of the above
Correct Answer: Auxiliary section
Correct Answer: 0 radius fillet
Correct Answer: plane
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.