Discussion
Home ‣ Technical Drawing ‣ 2D Drawing Representation Comments
- Question
This is a conical-shaped recess around a hole, often used to receive a tapered screw head:
Options- A. Boss
- B. Spotface
- C. Counterbore
- D. Countersink
- Correct Answer
- Countersink
- 1. These are used to attach parts to a cylinder so they won't turn on it:
Options- A. Lugs and bearings
- B. Keyseats and bearings
- C. Knurls and keys
- D. Keys and keyways/keyseats Discuss
- 2. This is a rounded exterior blend between surfaces:
Options- A. Fillet
- B. Round
- C. Taper
- D. Chamfer Discuss
- 3. These types of projectors converge at a vanishing point:
Options- A. Perspective
- B. Parallel
- C. Orthographic
- D. Oblique Discuss
- 4. When designing a home for a client, one of the most important pre-design considerations that an architect needs to address is ________.
Options- A. how much money the client is willing to spend.
- B. the site on which the house is to sit
- C. the nearest grocery store
- D. whether or not there is a curb and gutter system Discuss
- 5. A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
Options- A. architectural
- B. civil
- C. mechanical
- D. process piping Discuss
- 6. This is an angled surface used on cylinders to make them easier to handle:
Options- A. Fillet
- B. Taper
- C. Chamfer
- D. Lug Discuss
- 7. This is a flat or rounded tab protruding from a surface, usually to provide a method for attachment:
Options- A. Lug
- B. Boss
- C. Chamfer
- D. Spotface Discuss
- 8. This is a hollow cylinder that is often used as a protective sleeve or guide or as a bearing:
Options- A. Lug
- B. Bushing
- C. Chamfer
- D. Knurl Discuss
- 9. The principle reason for using an auxiliary view is ________.
Options- A. to eliminate hidden lines
- B. to create a true projection plane from an inclined plane in one of the primary views
- C. to show cylinders as ellipses
- D. to locate center marks Discuss
- 10. This type of surface may be a plane, a single curved surface, or a warped surface:
Options- A. Edge surface
- B. Ruled surface
- C. Auxiliary surface
- D. Developed surface Discuss
2D Drawing Representation problems
Search Results
Correct Answer: Keys and keyways/keyseats
Correct Answer: Round
Correct Answer: Perspective
Correct Answer: the site on which the house is to sit
Correct Answer: civil
Correct Answer: Chamfer
Correct Answer: Lug
Correct Answer: Bushing
Correct Answer: to create a true projection plane from an inclined plane in one of the primary views
Correct Answer: Ruled surface
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.