Discussion
Home ‣ Technical Drawing ‣ Technical Sketching Comments
- Question
Some of the common terms used to describe technical drawing include:
Options- A. Drafting
- B. Engineering Graphics
- C. Engineering Drawing
- D. All of the above
- Correct Answer
- All of the above
- 1. In oblique sketches, the most commonly used angles for receding lines are:
Options- A. 15 or 30 degrees
- B. 25 or 30 degrees
- C. 30 or 45 degrees
- D. 45 or 60 degrees Discuss
- 2. This type of solid has a polygon for a base and triangular lateral faces that intersect at a vertex:
Options- A. Pyramid
- B. Prism
- C. Cone
- D. Torus Discuss
- 3. This is formed where three or more surfaces intersect:
Options- A. Oblique
- B. Line
- C. Edge
- D. Vertex Discuss
- 4. Students can complete an associate's degree in drafting which normally takes about ________ years to complete.
Options- A. one
- B. two
- C. three
- D. four Discuss
- 5. An architect often relies on a ________ to complete the set of technical drawings used in the design of an office building.
Options- A. technical illustrator
- B. artist
- C. drafter
- D. construction superintendent Discuss
- 6. This type of solid has two bases that are parallel equal polygons:
Options- A. Pyramid
- B. Prism
- C. Cone
- D. Torus Discuss
- 7. A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
Options- A. architectural
- B. civil
- C. mechanical
- D. process piping Discuss
- 8. When designing a home for a client, one of the most important pre-design considerations that an architect needs to address is ________.
Options- A. how much money the client is willing to spend.
- B. the site on which the house is to sit
- C. the nearest grocery store
- D. whether or not there is a curb and gutter system Discuss
- 9. These types of projectors converge at a vanishing point:
Options- A. Perspective
- B. Parallel
- C. Orthographic
- D. Oblique Discuss
- 10. This is a rounded exterior blend between surfaces:
Options- A. Fillet
- B. Round
- C. Taper
- D. Chamfer Discuss
Technical Sketching problems
Search Results
Correct Answer: 30 or 45 degrees
Correct Answer: Pyramid
Correct Answer: Vertex
Correct Answer: two
Correct Answer: drafter
Correct Answer: Prism
Correct Answer: civil
Correct Answer: the site on which the house is to sit
Correct Answer: Perspective
Correct Answer: Round
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.