Discussion
Home ‣ Technical Drawing ‣ Isometric Drawings Comments
- Question
Before starting an isometric drawing in AutoCAD the drafter needs to ________.
Options- A. set the grid to isometric
- B. set the current layer to Defpoints
- C. turn Object Snap off
- D. turn Ortho off
- Correct Answer
- set the grid to isometric
- 1. A fillet is a rounded surface on the ________ corner of a part.
Options- A. Inside
- B. outside
- C. radial
- D. isoplane Discuss
- 2. When creating an isometric drawing in AutoCAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.
Options- A. horizontal
- B. vertical
- C. inclined
- D. none of the above Discuss
- 3. The bounding box method for setting up an isometric drawing helps the drafter ________.
Options- A. confine the isometric drawing to its maximum size
- B. figure what lines are to be illustrated vertical and horizontal
- C. position the isometric drawing in paper space
- D. none of the above Discuss
- 4. In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct isoplane has been selected by scrolling through the isoplanes using the ________ key.
Options- A. F1
- B. F3
- C. F5
- D. F8 Discuss
- 5. Isometric drawings are often used by ________ to help illustrate complex designs.
Options- A. mechanical engineers
- B. piping drafters
- C. aerospace engineers
- D. all of the above Discuss
- 6. One critical issue drafters need to pay close attention to is the ________.
Options- A. size of the sheet
- B. designer's intent
- C. scale factor
- D. none of the above Discuss
- 7. In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
Options- A. Detail
- B. title block
- C. parts list
- D. isometric Discuss
- 8. The title block used on working drawings should include the ________.
Options- A. sheet number
- B. line type
- C. layer set
- D. all of the above Discuss
- 9. The text used on a typical detail sheet should be ________.
Options- A. placed horizontally
- B. in bold text
- C. in an architectural text style
- D. none of the above Discuss
- 10. In the mechanical design process the first step is to ________.
Options- A. brainstorm solutions
- B. prepare rough sketches
- C. prepare a budget
- D. identify the problem Discuss
Isometric Drawings problems
Search Results
Correct Answer: Inside
Correct Answer: vertical
Correct Answer: confine the isometric drawing to its maximum size
Correct Answer: F5
Correct Answer: all of the above
Correct Answer: designer's intent
Correct Answer: Detail
Correct Answer: sheet number
Correct Answer: placed horizontally
Correct Answer: identify the problem
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.