Discussion
Home ‣ Technical Drawing ‣ Isometric Drawings Comments
- Question
Isometric drawings are often used by ________ to help illustrate complex designs.
Options- A. mechanical engineers
- B. piping drafters
- C. aerospace engineers
- D. all of the above
- Correct Answer
- all of the above
- 1. AutoCAD refers to isometric ellipses as ________.
Options- A. Ellipses
- B. isoellipses
- C. isocircles
- D. circles Discuss
- 2. A round is a rounded surface on the ________ corner of a part.
Options- A. inside
- B. outside
- C. radial
- D. isoplane Discuss
- 3. The Offset tool should only be used for placing ________ in an isometric drawing.
Options- A. circles
- B. horizontal lines
- C. vertical lines
- D. none of the above Discuss
- 4. Architectural drafters generally prefer to use ________ drawings to help illustrate 3-dimensional views of a structure.
Options- A. isometric
- B. perspective
- C. orthographic
- D. auxiliary Discuss
- 5. These are special installations of stone or concrete marking the locations of points accurately determined by precise surveying:
Options- A. Topographic marks
- B. Hatchures
- C. Monuments
- D. Pillars Discuss
- 6. In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct isoplane has been selected by scrolling through the isoplanes using the ________ key.
Options- A. F1
- B. F3
- C. F5
- D. F8 Discuss
- 7. The bounding box method for setting up an isometric drawing helps the drafter ________.
Options- A. confine the isometric drawing to its maximum size
- B. figure what lines are to be illustrated vertical and horizontal
- C. position the isometric drawing in paper space
- D. none of the above Discuss
- 8. When creating an isometric drawing in AutoCAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.
Options- A. horizontal
- B. vertical
- C. inclined
- D. none of the above Discuss
- 9. A fillet is a rounded surface on the ________ corner of a part.
Options- A. Inside
- B. outside
- C. radial
- D. isoplane Discuss
- 10. Before starting an isometric drawing in AutoCAD the drafter needs to ________.
Options- A. set the grid to isometric
- B. set the current layer to Defpoints
- C. turn Object Snap off
- D. turn Ortho off Discuss
Isometric Drawings problems
Search Results
Correct Answer: isocircles
Correct Answer: outside
Correct Answer: vertical lines
Correct Answer: perspective
Correct Answer: Monuments
Correct Answer: F5
Correct Answer: confine the isometric drawing to its maximum size
Correct Answer: vertical
Correct Answer: Inside
Correct Answer: set the grid to isometric
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.