logo

CuriousTab

CuriousTab

Discussion


Home Technical Drawing Isometric Drawings Comments

  • Question
  • AutoCAD refers to isometric ellipses as ________.


  • Options
  • A. Ellipses
  • B. isoellipses
  • C. isocircles
  • D. circles

  • Correct Answer
  • isocircles 


  • Isometric Drawings problems


    Search Results


    • 1. A round is a rounded surface on the ________ corner of a part.

    • Options
    • A. inside
    • B. outside
    • C. radial
    • D. isoplane
    • Discuss
    • 2. The Offset tool should only be used for placing ________ in an isometric drawing.

    • Options
    • A. circles
    • B. horizontal lines
    • C. vertical lines
    • D. none of the above
    • Discuss
    • 3. Architectural drafters generally prefer to use ________ drawings to help illustrate 3-dimensional views of a structure.

    • Options
    • A. isometric
    • B. perspective
    • C. orthographic
    • D. auxiliary
    • Discuss
    • 4. These are special installations of stone or concrete marking the locations of points accurately determined by precise surveying:

    • Options
    • A. Topographic marks
    • B. Hatchures
    • C. Monuments
    • D. Pillars
    • Discuss
    • 5. These are vertical distances above a common datum, reference plane, or point:

    • Options
    • A. Plats
    • B. Elevations
    • C. Traverse
    • D. Profiles
    • Discuss
    • 6. Isometric drawings are often used by ________ to help illustrate complex designs.

    • Options
    • A. mechanical engineers
    • B. piping drafters
    • C. aerospace engineers
    • D. all of the above
    • Discuss
    • 7. In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct isoplane has been selected by scrolling through the isoplanes using the ________ key.

    • Options
    • A. F1
    • B. F3
    • C. F5
    • D. F8
    • Discuss
    • 8. The bounding box method for setting up an isometric drawing helps the drafter ________.

    • Options
    • A. confine the isometric drawing to its maximum size
    • B. figure what lines are to be illustrated vertical and horizontal
    • C. position the isometric drawing in paper space
    • D. none of the above
    • Discuss
    • 9. When creating an isometric drawing in AutoCAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.

    • Options
    • A. horizontal
    • B. vertical
    • C. inclined
    • D. none of the above
    • Discuss
    • 10. A fillet is a rounded surface on the ________ corner of a part.

    • Options
    • A. Inside
    • B. outside
    • C. radial
    • D. isoplane
    • Discuss


    Comments

    There are no comments.

Enter a new Comment