logo

CuriousTab

CuriousTab

Discussion

Home ‣ Technical Drawing ‣ Isometric Drawings See What Others Are Saying!
  • Question

  • A round is a rounded surface on the ________ corner of a part.


  • Options
  • A. inside
  • B. outside
  • C. radial
  • D. isoplane

  • Correct Answer
  • outside 

    • More questions

    • 1. The Offset command can be used on vertical lines but not on horizontal lines.

    • Options
    • A. True
    • B. False
      • Discuss
    • 2. The primary difference between isometric drawings and perspective drawings is that in an isometric drawing both vertical and horizontal lines remain parallel while in a perspective drawing both horizontal and vertical lines are in line with an apparent vanishing point.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. The center line of a hidden cylinder feature appearing in the front view should line up with the center mark in the corresponding circle which appears in the auxiliary view.

    • Options
    • A. True
    • B. False
      • Discuss
    • 4. When dimensioning piping drawings, you give the lengths of all runs of this type:

    • Options
    • A. Straight
    • B. Angular
    • C. Filleted
    • D. Transverse
      • Discuss
    • 5. In working drawings for worm gears, gear teeth are omitted and the gear blank is represented conventionally.

    • Options
    • A. True
    • B. False
      • Discuss
    • 6. This allows the designer to conceptualize objects more easily without having to make costly illustrations, models, or prototypes:

    • Options
    • A. Computer-aided manufacturing
    • B. Computer-aided design
    • C. Computer-aided engineering
    • D. Computer-aided prototyping
      • Discuss
    • 7. In oblique sketches, the most commonly used angles for receding lines are:

    • Options
    • A. 15 or 30 degrees
    • B. 25 or 30 degrees
    • C. 30 or 45 degrees
    • D. 45 or 60 degrees
      • Discuss
    • 8. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.

    • Options
    • A. Linear dimension
    • B. Aligned dimension
    • C. Baseline dimension
    • D. Angle dimension
      • Discuss
    • 9. A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.

    • Options
    • A. architectural
    • B. civil
    • C. mechanical
    • D. process piping
      • Discuss
    • 10. When using the descriptive geometry method to create an auxiliary view the drafter should ________.

    • Options
    • A. rotate the snap grid to the same angle of the inclined plane
    • B. offset the right vertical line of the front view
    • C. rotate the top line of the front view 45 degrees
    • D. offset the top line of the front view 2 inches
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.