Discussion
Home ‣ Technical Drawing ‣ Landform Drawings Comments
- Question
This type of drawing is created to calculate areas, locate property lines, and locate building projects and facilities:
Options- A. Traverse
- B. Contour
- C. City map
- D. Plat
- Correct Answer
- Plat
- 1. Angles project true size only when the plane containing the angle and plane of projection are this:
Options- A. Adjacent
- B. Aligned
- C. Perpendicular
- D. Parallel Discuss
- 2. Lines of an isometric drawing that are not parallel to the isometric axes are called this:
Options- A. Trimetric lines
- B. Nonisometric lines
- C. Multiview lines
- D. Dimetric lines Discuss
- 3. In isometric projection, all distances are approximately this percentage of their true size:
Options- A. 120 percent
- B. 80 percent
- C. 50 percent
- D. 20 percent Discuss
- 4. The edges of a cube in isometric projection make angles of this many degrees with each other:
Options- A. 30
- B. 60
- C. 90
- D. 120 Discuss
- 5. This type of axonometric drawing has equal foreshortening along two axis directions and a different amount on the third axis:
Options- A. Dimetric
- B. Multiview
- C. Isometric
- D. Trimetric Discuss
- 6. These are lines drawn on a map to locate, in the plan view, points of equal ground elevation:
Options- A. Contours
- B. Elevations
- C. Profiles
- D. Hatchures Discuss
- 7. These maps are used to plan construction projects that locate construction features so they fit the topography of the area:
Options- A. Subdivision plats
- B. Landscape maps
- C. Structural topography maps
- D. Structure location plans Discuss
- 8. These maps are used in planning installations of trees, shrubbery, drives, and other garden features:
Options- A. Landscape maps
- B. Engineering maps
- C. Topographic maps
- D. Cadastral maps Discuss
- 9. These are accurately drawn maps of cities and towns showing property lines and other features that control property ownership:
Options- A. Monument maps
- B. Cadastral maps
- C. City maps
- D. Topographic maps Discuss
- 10. These are vertical distances above a common datum, reference plane, or point:
Options- A. Plats
- B. Elevations
- C. Traverse
- D. Profiles Discuss
Landform Drawings problems
Search Results
Correct Answer: Parallel
Correct Answer: Nonisometric lines
Correct Answer: 80 percent
Correct Answer: 120
Correct Answer: Dimetric
Correct Answer: Contours
Correct Answer: Structure location plans
Correct Answer: Landscape maps
Correct Answer: Cadastral maps
Correct Answer: Elevations
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.