Discussion
Home ‣ Technical Drawing ‣ Axonometric Projection Comments
- Question
In this type of projection, each of the axes has different ratios of foreshortening:
Options- A. Isometric
- B. Dimetric
- C. Trimetric
- D. Parallel
- Correct Answer
- Trimetric
- 1. In working drawings, these show all necessary information not given directly on the drawing with its dimensions and notes:
Options- A. Document strips
- B. Portable documents
- C. Formatting forms
- D. Title and record strips Discuss
- 2. These are groups of components of a larger machine:
Options- A. Subassemblies
- B. External assemblies
- C. Component assemblies
- D. Major assemblies Discuss
- 3. An accurate record of changes made to released drawings is tracked via this:
Options- A. A revision block
- B. The basic title form
- C. Working drawings
- D. Portable documents Discuss
- 4. In these drawings it is necessary to show cut surfaces and distinguish between adjacent parts:
Options- A. Auxiliary drawings
- B. Assembly sections
- C. 3D assemblies
- D. Parts lists Discuss
- 5. In an assembly section, these parts should have their section lines left out or shown solid black:
Options- A. Bolts
- B. All fasteners
- C. Thin parts
- D. Rivets Discuss
- 6. This type of axonometric drawing has equal foreshortening along two axis directions and a different amount on the third axis:
Options- A. Dimetric
- B. Multiview
- C. Isometric
- D. Trimetric Discuss
- 7. The edges of a cube in isometric projection make angles of this many degrees with each other:
Options- A. 30
- B. 60
- C. 90
- D. 120 Discuss
- 8. In isometric projection, all distances are approximately this percentage of their true size:
Options- A. 120 percent
- B. 80 percent
- C. 50 percent
- D. 20 percent Discuss
- 9. Lines of an isometric drawing that are not parallel to the isometric axes are called this:
Options- A. Trimetric lines
- B. Nonisometric lines
- C. Multiview lines
- D. Dimetric lines Discuss
- 10. Angles project true size only when the plane containing the angle and plane of projection are this:
Options- A. Adjacent
- B. Aligned
- C. Perpendicular
- D. Parallel Discuss
Axonometric Projection problems
Search Results
Correct Answer: Title and record strips
Correct Answer: Subassemblies
Correct Answer: A revision block
Correct Answer: Assembly sections
Correct Answer: Thin parts
Correct Answer: Dimetric
Correct Answer: 120
Correct Answer: 80 percent
Correct Answer: Nonisometric lines
Correct Answer: Parallel
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.