Discussion
Home ‣ Technical Drawing ‣ Working Drawings Comments
- Question
An accurate record of changes made to released drawings is tracked via this:
Options- A. A revision block
- B. The basic title form
- C. Working drawings
- D. Portable documents
- Correct Answer
- A revision block
- 1. In these drawings it is necessary to show cut surfaces and distinguish between adjacent parts:
Options- A. Auxiliary drawings
- B. Assembly sections
- C. 3D assemblies
- D. Parts lists Discuss
- 2. In an assembly section, these parts should have their section lines left out or shown solid black:
Options- A. Bolts
- B. All fasteners
- C. Thin parts
- D. Rivets Discuss
- 3. These drawings are given to contractors to perform work or manufacture individual parts:
Options- A. Assembly details
- B. 3D drawings
- C. Working drawings
- D. Skeleton assemblies Discuss
- 4. This should show what changes were made, when, and by whom:
Options- A. Portable document
- B. Record of revisions
- C. Title form
- D. Revision drawings Discuss
- 5. When lines intersect on a drawing at angles of this many degrees, it is customary not to dimension the angle:
Options- A. 360
- B. 180
- C. 90
- D. 45 Discuss
- 6. These are groups of components of a larger machine:
Options- A. Subassemblies
- B. External assemblies
- C. Component assemblies
- D. Major assemblies Discuss
- 7. In working drawings, these show all necessary information not given directly on the drawing with its dimensions and notes:
Options- A. Document strips
- B. Portable documents
- C. Formatting forms
- D. Title and record strips Discuss
- 8. In this type of projection, each of the axes has different ratios of foreshortening:
Options- A. Isometric
- B. Dimetric
- C. Trimetric
- D. Parallel Discuss
- 9. This type of axonometric drawing has equal foreshortening along two axis directions and a different amount on the third axis:
Options- A. Dimetric
- B. Multiview
- C. Isometric
- D. Trimetric Discuss
- 10. The edges of a cube in isometric projection make angles of this many degrees with each other:
Options- A. 30
- B. 60
- C. 90
- D. 120 Discuss
Working Drawings problems
Search Results
Correct Answer: Assembly sections
Correct Answer: Thin parts
Correct Answer: Working drawings
Correct Answer: Record of revisions
Correct Answer: 90
Correct Answer: Subassemblies
Correct Answer: Title and record strips
Correct Answer: Trimetric
Correct Answer: Dimetric
Correct Answer: 120
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.