Discussion
Home ‣ Technical Drawing ‣ Working Drawings Comments
- Question
This should show what changes were made, when, and by whom:
Options- A. Portable document
- B. Record of revisions
- C. Title form
- D. Revision drawings
- Correct Answer
- Record of revisions
- 1. When lines intersect on a drawing at angles of this many degrees, it is customary not to dimension the angle:
Options- A. 360
- B. 180
- C. 90
- D. 45 Discuss
- 2. Acceptable parts must not extend beyond this:
Options- A. Boundary limits
- B. Hole limits
- C. Specification
- D. Tolerances Discuss
- 3. This is the theoretically exact size from which limits of size are determined:
Options- A. Actual Size
- B. Dimensioned size
- C. Production size
- D. Basic size Discuss
- 4. This means that a feature of a finished product contains the maximum amount of material permitted by the toleranced dimensions for that feature:
Options- A. Maximum material condition
- B. Machined material condition
- C. Maximum machined indication
- D. Machine mark indication Discuss
- 5. This is the term for the range of tightness or looseness resulting from the allowances and tolerances in mating parts:
Options- A. Limits
- B. Fit
- C. Specifications
- D. Allowance Discuss
- 6. These drawings are given to contractors to perform work or manufacture individual parts:
Options- A. Assembly details
- B. 3D drawings
- C. Working drawings
- D. Skeleton assemblies Discuss
- 7. In an assembly section, these parts should have their section lines left out or shown solid black:
Options- A. Bolts
- B. All fasteners
- C. Thin parts
- D. Rivets Discuss
- 8. In these drawings it is necessary to show cut surfaces and distinguish between adjacent parts:
Options- A. Auxiliary drawings
- B. Assembly sections
- C. 3D assemblies
- D. Parts lists Discuss
- 9. An accurate record of changes made to released drawings is tracked via this:
Options- A. A revision block
- B. The basic title form
- C. Working drawings
- D. Portable documents Discuss
- 10. These are groups of components of a larger machine:
Options- A. Subassemblies
- B. External assemblies
- C. Component assemblies
- D. Major assemblies Discuss
Working Drawings problems
Search Results
Correct Answer: 90
Correct Answer: Boundary limits
Correct Answer: Basic size
Correct Answer: Maximum material condition
Correct Answer: Fit
Correct Answer: Working drawings
Correct Answer: Thin parts
Correct Answer: Assembly sections
Correct Answer: A revision block
Correct Answer: Subassemblies
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.