Discussion
Home ‣ Technical Drawing ‣ Dimensioning Comments
- Question
The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.
Options- A. Linear
- B. Continue
- C. Baseline
- D. Quick Dimension
- Correct Answer
- Quick Dimension
- 1. How can the drafter prevent AutoCAD from placing or stacking another center mark on a circle when adding a diameter dimension to it?
Options- A. Explode the dimension and then erase the center mark.
- B. Use the Properties dialog box to turn off the center mark of the dimension.
- C. It can't be done.
- D. Use the trim tool to take away the stacked center mark. Discuss
- 2. Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?
Options- A. Use the Modify tool to clean up the extension lines.
- B. Use the Tolerance tool to clean up the extension lines.
- C. Use the Break tool to clean up the extension lines.
- D. Use the stretch tool to clean up the extension lines. Discuss
- 3. In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches:
Options- A. One inch or over
- B. One foot or over
- C. One yard or over
- D. One rod or over Discuss
- 4. In this type of dimensioning, allowance must be made for bends:
Options- A. Angular
- B. Tolerance
- C. Datum
- D. Sheet metal Discuss
- 5. The ________ dimension tool will place the length of an angled line.
Options- A. Aligned
- B. Angle
- C. Linear
- D. Radial Discuss
- 6. This is the measured size of a finished part:
Options- A. Actual size
- B. Dimensioned size
- C. Production size
- D. Basic size Discuss
- 7. This practice considers an individual part's dimensions and tolerances and that part's relation to its related parts:
Options- A. Applying allowances
- B. Geometric dimensioning and tolerancing
- C. Creating datum references
- D. Angular dimensioning tolerances Discuss
- 8. This is the term for the range of tightness or looseness resulting from the allowances and tolerances in mating parts:
Options- A. Limits
- B. Fit
- C. Specifications
- D. Allowance Discuss
- 9. This means that a feature of a finished product contains the maximum amount of material permitted by the toleranced dimensions for that feature:
Options- A. Maximum material condition
- B. Machined material condition
- C. Maximum machined indication
- D. Machine mark indication Discuss
- 10. This is the theoretically exact size from which limits of size are determined:
Options- A. Actual Size
- B. Dimensioned size
- C. Production size
- D. Basic size Discuss
Dimensioning problems
Search Results
Correct Answer: Use the Properties dialog box to turn off the center mark of the dimension.
Correct Answer: Use the Modify tool to clean up the extension lines.
Correct Answer: One foot or over
Correct Answer: Sheet metal
Correct Answer: Aligned
Correct Answer: Actual size
Correct Answer: Geometric dimensioning and tolerancing
Correct Answer: Fit
Correct Answer: Maximum material condition
Correct Answer: Basic size
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.