logo

CuriousTab

CuriousTab

Discussion


Home Technical Drawing Dimensioning Comments

  • Question
  • The ________ dimension tool will place the length of an angled line.


  • Options
  • A. Aligned
  • B. Angle
  • C. Linear
  • D. Radial

  • Correct Answer
  • Aligned 


  • Dimensioning problems


    Search Results


    • 1. Placement of dimensions on a drawing is controlled by ________.

    • Options
    • A. ANSI
    • B. The design engineer
    • C. Corporate drafting standards
    • D. All of the above
    • Discuss
    • 2. The maximum and minimum sizes of a feature are identified by a ________ tolerance.

    • Options
    • A. Limits
    • B. GD&T
    • C. reference
    • D. allowance
    • Discuss
    • 3. A circular arc is dimensioned in the view where you see its true shape by giving the value for its:

    • Options
    • A. Diameter
    • B. Arc length
    • C. Radius
    • D. Chord length
    • Discuss
    • 4. The condition of a part when it contains the least amount of material is referred to as ________.

    • Options
    • A. smallest
    • B. LMC
    • C. MMC
    • D. actual size
    • Discuss
    • 5. One way to evenly space dimensions on a drawing is to use the ________.

    • Options
    • A. Dimension Space tool
    • B. Linear tool
    • C. Continue tool
    • D. Baseline tool
    • Discuss
    • 6. In this type of dimensioning, allowance must be made for bends:

    • Options
    • A. Angular
    • B. Tolerance
    • C. Datum
    • D. Sheet metal
    • Discuss
    • 7. In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches:

    • Options
    • A. One inch or over
    • B. One foot or over
    • C. One yard or over
    • D. One rod or over
    • Discuss
    • 8. Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?

    • Options
    • A. Use the Modify tool to clean up the extension lines.
    • B. Use the Tolerance tool to clean up the extension lines.
    • C. Use the Break tool to clean up the extension lines.
    • D. Use the stretch tool to clean up the extension lines.
    • Discuss
    • 9. How can the drafter prevent AutoCAD from placing or stacking another center mark on a circle when adding a diameter dimension to it?

    • Options
    • A. Explode the dimension and then erase the center mark.
    • B. Use the Properties dialog box to turn off the center mark of the dimension.
    • C. It can't be done.
    • D. Use the trim tool to take away the stacked center mark.
    • Discuss
    • 10. The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.

    • Options
    • A. Linear
    • B. Continue
    • C. Baseline
    • D. Quick Dimension
    • Discuss


    Comments

    There are no comments.

Enter a new Comment